Hazards When Using And Handling The Power Tool; Service / Maintenance / Repair - Baier BSM 287 Traduction Du Mode D'emploi Original

•
Keep the mains power lead away from
rotating insert tools.
If you lose control of the tool, the mains power
lead can be cut or caught and your hand or arm
can be pulled into the rotating insert tool.
•
Never put down the power tool until the
insert tool has come to a complete standstill.
The rotating insert tool can come into contact
with the surface on which the power tool is
placed, which could cause you to lose control of
the power tool.
•
Do not leave the power tool running while
you are carrying it.
Your clothing can get caught by inadvertent
contact with the rotating insert tool and the
insert tool can drill into your body.
•
If the machine is switched on, do not direct
insert tools towards your own or other
people's bodies. Do not touch or take hold
of the tools.
2.6.5 Hazards when using and
handling the power tool
•
The approved speed of the insert tool must
be at least as high as the maximum speed
given on the power tool.
Accessories which rotate faster than approved
can break and fly off the tool.
•
Change insert tools carefully and only use
the mounting tools provided, if they are in
perfect condition. Disconnect the mains
plug before changing the insert tool.
Use of the mounting tool provided prevents
damage to the power tool and insert tool.
•
Do not expose power tools to extreme heat
or cold.
Mechanical and electrical damage can occur
during extreme heat and/or cold.
•
Allow the insert tools, tool holders and other
parts cool in the immediate vicinity of the
work area after use.
The equipment can be very hot after use. Do not
touch or grip the parts. Risk of injury.
•
Additional signs or other, non BAIER-
specific parts may not be screwed or
riveted onto the motor, handle, gearbox or
protective housing.
This could damage the power tool and cause
malfunctions to occur.
•
Avoid unnecessary noise emissions.
•
Note and follow the safety and work
instructions for the accessories used.
•
When switching on and while working with
the power tool, hold onto it tightly at both
handles and place your body and arms
in a position in which they can absorb
the kickback forces or reaction torque on
starting up.
The person using the tool can control the
kickback and reaction forces by taking suitable
precautions.

2.6.6 Service / Maintenance / Repair

•
If the power tool is dropped or becomes wet,
have it checked.
A possibly damaged power tool is dangerous
and no longer safe to operate. Before using
the power tool again, have it checked by our
customer service or an authorised service
centre of Maschinenfabrik OTTO BAIER GmbH.
•
Repair and maintenance work may only be
carried out by an authorised workshop of
Maschinenfabrik OTTO BAIER GmbH.
Otherwise, all liability and warranty claims
against Maschinenfabrik OTTO BAIER GmbH
expire.
•
Ensure that original BAIER spare parts and
original BAIER accessories only are used
when needed.
Original parts are available from authorised
dealers. Use of non original parts can cause
damage to the machine and an increased risk of
accidents.
NOTE
If using new carbon brushes, the machine may
not be overloaded during the first 10 minutes of
operation.
•
Regular servicing by Maschinenfabrik OTTO
BAIER GmbH or a servicing and repair
company authorised by us is specified.
Many accidents are caused by poorly serviced
and maintained power tools.
| 25 |