Preparing The Remote Control; Preparing The Media - THOMSON MIC120BT Mode D'emploi

Preparing the remote control

• Use alkaline battery. (not supplied)
• Install the battery so that the poles (+ and -) align with those in the remote control.
• Close the battery compartment..
Note: If you are not going to use the remote control for a long time, remove the battery.
Batteries contain chemical substances, so they should be disposed of properly.
ATTENTION: Danger of explosion if batteries are not inserted correctly.

Preparing the media

Disc
1. Press [CD] (main unit:
2. Put in a disc with the label facing up.
3. Press again to close the disc tray, the "READING" shown.
USB
1. Reduce the volume and connect the USB device to the USB port
2. Hold the main unit when connecting or disconnecting the USB device
3. Press [USB] or press repeatedly [Source] on main unit to select "USB", the "READING"
shown.
Bluetooth
®
You can connect and play an audio device wirelessly through Bluetooth
Preparation
• Switch on the Bluetooth
• Read the operation instructions of the device for details.
Pairing a device
1. Press , the "PAIRING" is shown,
2. Select "MIC120BT (MIC122BT/MIC125BT)" from the Bluetooth menu of the device. If
prompted for a passkey, input "0000" The device connects with this system automatically
) to open the disc tray.
feature of device and put the device near the system.
®
- EN 16 -
®