Remote Control; Power; Setting Clock; Setting Alarm - THOMSON DS301 Mode D'emploi

Remote Control

1. Power

2. Sleep
3. Mute
4. Timer
5. Clock
6. Source
7. Previous
8. Enter
9. Next
10. Memory
11. Memory
12. Memory +
13. Treble+
14. Bass+
15. Volume+
16. Treble
17. Bass
18. Volume
Using the Remote Control the Battery
Pull the clear tab from the battery compartment at the base (straight) end of the remote.
If your remote becomes intermittent or you find you have to move nearer the unit to
operate, the battery probably needs to be replaced. To replace the battery, slide the
battery holder from the base of the remote control. Remove the battery and replace
with 2PCS 1.5v AAA battery ensuring the +side is on the underside of the
holder as you slide it back into the compartment.
Setting up Your Tower
Carefully take the tower body and base out of the packaging. Stand the tower upright
on the floor. The appliance is now ready for use.
Power
Place the unit in the desired position and unravel the mains cable. Insert the cable into the supply socket and switch on
if applicable.

Setting Clock

After the unit is plugged into a mains supply or mains power failure, the display will show the "0:00" on the LCD display.
The unit should be in standby mode to set the current clock.
1. Press TIMER button, the digits for the display will blink.
1. 2 .Press the PREVIOUS/NEXT button repeatedly until correct hour is set. Press the TIMER to confirm.
2. The hour setting; the minute digits on the display will blink.
3. Press the PREVIOUS/NEXT button repeatedly until correct minute is set. Press the TIMER to confirm the
minute setting.

Setting Alarm

Press and hold TIME button in shutdown state, the display will flash ON/OFF to select setting alarm or canceling alarm.
Press PREVIOUS/NEXT to select ON, and the display will blink.
Press PREVIOUS/NEXT button repeatedly to set hour. Press TIME to confirm, then press PREVIOUS/NEXT to set minute.
Press TIME to confirm, and then press PREVIOUS/NEXT to select FM/Aux in status. Press TIME to confirm.

Sleep Mode

Press the SLEEP button, the display will blink. Press the button until the display shows the minute you want to set. You
can set 10 to 90 minutes.
It blinks three times to confirm, and then return to the interface before. If you want to cancel the sleep mode, press to
00, after blanking three times, the sleep mode will cancel.
Remark
:
In order to save energy when the unit has no sound output for a while, the unit will be switched to stand by
automatically. It can be switched ON by using the function selector again.
GB 4