Rear panel
Type:
OMNITRONIC P-1000
Power consumption(max.): 30W
Power supply:115/230VAC,50/60Hz~
Nominal Power output:
Fuse:
(9) AC-CONNECTION
Used to plug the power cord in.
(10) FUSEHOLDER
Only replace the fuse when the device is disconnected from mains. Only use fuses of the same rating and
power.
(11) AC VOLTAGE-SELECTOR
Make sure that the selector is properly set.
(12) MONO BRIDGE-OUTPUT SOCKET
For connecting the speakers in bridged mode.
(13) CH-2-SPEAKON-OUTPUT SOCKET
For connecting the speakers of channel 2.
(14) CH-2-BANANA/SCREW COMBINATION
For connecting the speakers of channel 2.
(15) CH-1-BANANA/SCREW COMBINATION
For connecting the speakers of channel 1.
(16) CH-1-SPEAKON-OUTPUT SOCKET
For connecting the speakers of channel 1.
(17) VR FOR LIGHT-CONTROL
For adjusting the LED-intensity.
(18) PARALLEL/DUAL/BRIDGE-MODE SELECTOR
For selecting the desired operation mode.
(19) CH-2 JACK INPUT SOCKET
Connect the input signal here using a balanced ¼" stereo jack.
(20) CH-2 XLR INPUT SOCKET
Connect the input signal here using a balanced XLR-plug.
(21) INPUT SENSITIVITY-SELECTOR
For selecting the desired input sensitivity.
(22) CH-1 XLR INPUT SOCKET
Connect the input signal here using a balanced XLR-plug.
(23) CH-1 JACK INPUT SOCKET
Connect the input signal here using a balanced ¼" stereo jack.
(24) GROUND LIFT-SELECTOR
INSTALLATION
RACK-INSTALLATION
This amplifier is built for 19" racks (483 mm). The rack you use should be a Double-Door-Rack where you
can open the frontpanel and the rear panel. The rack should be provided with a cooling fan. When mounting
the Amplifier into the rack, please make sure that there is enough space around the device so that the
heated air can be passed on. Steady overheating will damage your device.
You can fix the amplifier with four screws M6 in the rack.
9
10
11
2X400W/4 Ohms
8A/250V
17
18
19
12
13
14
15
26dB
20
21
22
23
18
16
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
24