Intended Use; Unpacking; Assembling The Support Rod - IKA DRY BLOCK HEATER 1 Mode D'emploi

• Use
- For heating media in block heaters
• Area of use
Indoor environments similar to that a laboratory of research,
teaching, trade or industry area.
•

Unpacking

- Please unpack the device carefully
- In the case of any damage a fact report must be sent imme-
diately (post, rail or forwarder)
• Review the mounting and safety instructions of the IKA boss
head clamp prior to using it.
• The device must not be suspended from the support rod!
12

Intended use

The safety of the user cannot be guaranteed:
- if the device is operated with accessories that are not sup-
plied or recommended by the manufacturer,
- if the device is operated improperly or contrary to the
manufacture's specifications,
- if the device or the printed circuit board are modified by
third parties.
Unpacking
•
Scope of delivery
- IKA DRY BLOCK HEATER
Depending on the IKA DRY BLOCK HEATER model 1, 2, 3, or
4
- Mains cable
- Temperature sensor PT 1000.60
- Operating instructions

Assembling the support rod

below with a dotted rectangle.
17 mm
4.
4.
3.
2.
3. 2.
1.
1.
Risk of tipping! Make sure that the cen-
WARNING
ter of mass of the attached device does
not protrude over the safe area indicated