Correct Use; Assembling The Stand - IKA Dry Block Heater 1 Mode D'emploi

•
Unpacking
- Please unpack the device carefully
- In the case of any damage a fact report must be sent imme-
diately (post, rail or forwarder)
• Use
- For heating media in block heaters
• Range of use (interior areas only)
- Laboratories - Schools
- Pharmacies - Universities
 Remove the protective cap from the support rod.
 Put the washer between housing and nut.
 Screw the support rod onto the device by hand until the end
stop is reached.
Unpacking
•
Delivery scope
- IKA ®
Depending on the IKA
- Mains cable
- Temperature sensor PT 1000.60
- Operating instructions

Correct use

The safety of the user cannot be guaranteed if the appliance is
operated with accessories that are not supplied or recommended
by the manufacturer or if the appliance is operated improperly
contrary to the manufacturer's specifications or if the appliance
or the printed circuit board are modified by third parties.

Assembling the stand

 Using an open-jaw spanner 17 AF gently tighten the nut
(tightening torque max. 0.5 Nm).
 Accessories should be attached using cross sleeves.
Dry Block Heater,
® Dry Block Heater model 1.2, 3, or 4
Fig. 3
12