Installing The Oliboard Software; Installing The Software Driver For The Usb Cable - Olivetti OLIBOARD Manuel De L'utilisateur

Installing the Oliboard Software

1. Click
2. Choose the language you want to install.
3. Select the installation path. The software installation starts.
4. When installation completes a message appears; click on "Finish".

Installing the Software Driver for the USB Cable

Normally it is not necessary to execute this procedure if the "Express installation" has
already been performed.
1. Click
cable.
2. Click "Install FTDI Driver" to install the driver.
After connecting the cable, click "OK". If the installation completes correctly, a
message to this effect is displayed.
You can check if the USB cable driver has been installed by clicking with the mouse
right button on "Computer Resources", then with the mouse left button on
"Properties" → "Hardware" → "Device Manager" → "Port" (COM and LPT)".
The device "USB Serial Port" is shown. Make sure that the COM port assigned is less
than 10 (e.g. COM 5) and that the transmission speed is 57600.
OLIBOARD - Interactive Whiteboards
.
"Install USB Driver" to install the driver for the USB
13