Troubleshooting - FUXTEC FX-DH116 Mode D'emploi Original

Circuit diagram:
16.

Troubleshooting

Fault
The engine does not start
E1 Error on the display
The engine runs, but the heater
does not ignite and locks after a
short time
Original User Manual FUXTEC FX-DH116_rev03
Cause
-
No current or low voltage
-
Power cable defective or
damaged
-
Engine/Capacitor defect
-
Device locked due to
overheating
-
Empty fuel tank, dirty or
wrong fuel
-
Fuel filter clogged
-
Hole in the oil line
-
Burner nozzle clogged
-
Fuel Viscosity not good
29
Measure
-
Check the power line and
voltage, check the fuse
-
Check the power cord and
replace it
-
Check the engine and
capacitor and replace it if
necessary.
-
Determine the cause of
overheating
-
Wait a few minutes and
restart the device
-
Remove wrong or dirty fuels
-
Fill the tank with clean
diesel
-
Clean or replace the fuel
filter
-
Check Hoses
-
Clean nozzle, blow in
compressed air