Tristar BL-4433 Mode D'emploi page 8

Instruction manual
TRouBle ShooTINg
Problems
The unit is not working and
beeping
The unit has stopped in the mid-
program (during the operation)
Ingredients pieces are still too large
after the cycle is complete (food is
not well blended.)
8
cause and solution
1. The jug is not properly fitted
onto the base, press on the jug.
2. The lid is not fitted properly
make sure the marks on the lid
and the jug will match.
3. There is not enough liquid in
the jug, add more liquid.
4. There are some spills around
the over-flow sensor.
1. The lid is loose, make sure the
marks on the lid and the jug will
match.
2. Liquid level is too low due to
evaporation during cooking fill on
the liquid through the refill hole.
3. Liquid is too much than the
maximum, pour out some liquid.
4. The jug is gone loose from the
base. Press on the jug and the
process will resume.
1. Pieces were possibly too large.
Initially-use the blend function
after the cooking program.
2. Wrong function was selected:
try another one.
3. Poured less water: Add
sufficient water.
Problems
The ingredients are hard after the
cooking cycle. (food cooked not
well)
The soup is not hot and the
cooking cycle appeared to finish
early.
Food is burnt, and stuck to the
bottom.
cause and solution
1. Chop the ingredients into small
pieces before adding.
2. Wrong function was selected:
try another one.
3. Too much water or food, filter
is clogged try again with other
amounts.
4. Some food require longer
cooking: select reheat function
till the food is fully cooked.
There was too much hot liquid
in the jug. Through the blend
movement the soup reached
during cooking the upper overflow
sensor. Pour out a little amount
and choose the reheat function.
1. Caused by high sugar or starch:
use proper sugar, or starch.
2. Too much food and too little
liquids, try again with other
amounts.