Miele STB 201 Mode D'emploi page 56

U
Operation
Attaching the Turbobrush to
the Miele Vacuum Cleaner
Model STB 205
This Turbobrush is intended for use with
Miele vacuum cleaners only.
^ Insert the suction wand into the neck
of the turbobrush as shown. If the
locking mechanism does not com-
pletely engage, gently twist the wand
while it is in the neck until it clicks into
place.
^ To remove the turbobrush, press the
release button while pulling the suc-
tion wand out of the neck of the
turbobrush.
Model STB 201
This turbobrush has an adjustable
collar that will allow it to be used on
suction wands with a diameter of
3 1
1 / inch - 1 / inch (30 - 38 mm). It
16 2
should be used on high performance
vacuums, otherwise the overall perfor-
mance of the vacuum may be compro-
mised.
56