Gladiator Garageworks 2254086D Instructions D'assemblage page 4

P1
P6
A. Leveling legs
3. Stand the cabinet upright.
4. If you have not already, fasten the two bolts at each front corner,
of the cabinet frame. Completely tighten all the cabinet bolts and
nuts.
Assemble Drawer
F3c Phillips-head screw (22 - black)
IMPORTANT:
Position the drawer sides so that the glides are at the top and
facing the outside.
Do not fully tighten the six screws attaching the drawer back to
the sides.
1. Using three Phillips-head screws (F3c), attach the side (D1) to the
back (D2) as shown.
NOTE: Working from the back, insert the screws through the
drawer back and then into the drawer side.
2. Using three Phillips-head screws (F3c), attach side (D3) to the
back (D2) as shown.
NOTE: Working from the back, insert the screws through the
drawer back and then into the drawer side.
3. Working from the top, set the drawer bottom (D4) down onto the
back and side flanges as shown.
4. Working from the bottom, insert screws through the drawer back
and sides and then into the drawer bottom.
NOTE: Wait until the drawer front is in place before inserting the
screws that attach the drawer bottom to the front.
D1
4
P7
P4
A
F3c
D4
D2
D3
5. Using nine Phillips-head screws (F3c), attach the drawer front
(D5) to the bottom and sides.
D3
D2
A. Drawer glide lever
6. Before you insert the drawer into the cabinet, make sure the
bearing carriages on the cabinet slides are at the front of the
cabinet.
7. Align the drawer glides with the slides on the inside of the
cabinet. Insert the drawer glides into the slides and push the
drawer into the cabinet.
NOTE: If the drawer glide is not correctly aligned with the cabinet
slide, the drawer may become lodged in the cabinet. Facing the
cabinet, press down on the lever located on the right-hand
drawer glide while pressing up on the lever located on the left-
hand drawer glide to release the drawer.
8. Once the drawer is in place, work from the rear of the cabinet to
completely tighten the six screws attaching the drawer back.
D2
P3
P6
A. Tighten drawer screws.
Attach Upper Back Panel
F3c Phillips-head screw (9 - black)
1. Align back panel (P5) with the holes in the top (P2). Using seven
Phillips-head screws (F3c), attach back panel (P5) to the top (P2)
and sides (P1 and P3) as shown. Do not tighten screws
completely.
NOTE: Back panel (P5) will slightly overlap back panel (P6)
2. Using two Phillips-head screws (F3c), attach the upper back
panel (P5) to the lower back panel (P6) as shown.
D5
D4
D1
A
A
P2
P1
F3c