Nice NiceWay WM080G Manuel D'utilisation page 7

5
10"
(A, B, C, D)
(01, 02, 03, ....)
(A, B, C, D)
(01, 02, 03, ....)
(A, B, C, D)
be set for each one, repeating the proce-
EN
dure described in points 02, 03, 04 and 05.
At any time, or at the end of all operations,
the user can exit the procedure by press-
ing ■(2), or by waiting for the transmitter to
switch off automatically.
– See summarised
example in Fig.
14
Personalising radio code
If your "Automation List" contains automa-
tions associated with the radio code type
, the 10 dip-switches on which this code
A B
C D
is based now need to be set, for each
automation. To do this, proceed as follows:
01. With the transmitter switched off,
B
press and hold the key OK for approx.
10 seconds, until the display shows
the symbol
A
"PROG") then release the key immedi-
ately.
02. Press keys – / + to select the Number
of the automation using radio code
D
03. Then press OK to enter the mode for
setting the Dipswitches: the display
A
shows the current setting of dipswitch
no. 01 (Fig.
04. To modify the setting of dipswitch no.
A
01, refer to Fig.
to select On or ▼(3) to select Off, as
required.
7
10"
➐
–
— Step 2.1 —
- - - , (after the text
➏
).
➏
and then press ▲(1)
A B
C D
C
(01, 02, 03, ....)
C
(On)
C
(Off)
C
(01, 02, 03, ....)
C
05. Then move to the next dipswitch by
pressing key + (or key – to the previ-
ous one) and use keys ▲(1) / ▼(3), to
select the required setting for this dip-
switch, i.e. either On or Off.
Then set the remaining dipswitches
(total 10), repeating point 05 for each
one, and after reaching dipswitch no.
10, press OK to terminate and exit the
procedure.
If your "Automation List" contains other
automations associated with the radio
code type , the relative Dipswitches must
.
Dipswitch status (On / Off)
ON
C
OFF
Dipswitch no. (01 / 10)
— Step 3
MEMORISING THE CODE SENT
BY THE TRANSMITTER IN
THE RECEIVER
Each Number in the transmitter is associ-
ated with its own "identity code" which
enables the transmitter to be recognised
by the receiver of an automation whenever
a command is sent.
In this step, this "identity code" must be
memorised in each automation Receiver,
to then enable the latter to recognise the
commands sent by the transmitter. To do
this, proceed as follows:
01. In the "Automation List" locate the
Number of the automation in which
the Receiver is to memorise the "iden-
tity code" of your transmitter.
With the transmitter switched off,
press keys – / + to select this Number.
02. Press ■ (2): after a brief interval the
transmitter switches off, but keeps the
Number of the previously selected
automation in the memory.
EN
6
13
—