Publicité
Les langues disponibles
Les langues disponibles
Instructions for VM160
How to learn a remote?
1- Press and hold "Setup" button.
2- Press and hold remote channel 1 button.
3- All LEDs light = remote accepted.
4- Release "Setup" button.
How to set the output function for each channel?
Select a timer function between "Moment" and "On/
Off". A function is indicated by LEDs 1 to 4 and
column LED*.
1- Press and hold "Setup" button.
To remove all remotes from memory :
Turn off the power (disconnect power supply)
Hold 'setup' button
Turn on power (connect power supply)
Mode led will blink.
Release 'setup' when LED turns off
This process takes about 10 seconds.
If the button is released before the LED's turn off, the memory will not be cleared.
The unit will now respond to the default code only >> please also reset the transmitter code.
On a transmitter:
2- Press channel 1 button repeatedly to
select function for channel 1.
3- Press channel 2 button repeatedly to
select function for channel 2.
4- Press channel 3 button repeatedly to
select function for channel 3.
5- Press channel 4 button repeatedly to
select function for channel 4.
6- Release "setup" button.
* Note:
LED on = left column selection.
Instructions
5
Publicité
