Overview Of The Components - Clatronic KM 3610 Mode D'emploi

WARNING: Risk of injury!
• Appliances can be used by persons with reduced physical, sen-
sory or mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning use of
the appliance in a safe way and if they understand the hazards
involved.
CAUTION:
Do not immerse the device into water for cleaning. Please follow the
instructions as stipulated in the chapter "Cleaning".
• Do not manipulate safety switches.
• Only process foodstuffs with this appliance.
• Misuse of the appliance for other purposes may cause injury.

Overview of the Components

1 Swivel arm
2 LED display
3 / timer buttons
4 button for raising / lowering the arm
5 Control knob
6 Kneading hook
7 Mixing hook
8 Egg beater
9 Mixing bowl
10 Splash guard
Preparation
• Remove the appliance and all included accessories from
the box.
• In order to remove any production residue, clean all acces-
sories before initial use as described under "Cleaning".
Electrical Connection
• Ensure that your mains power corresponds with the specifi-
cations on the type label.
Use Instruction
1. Fully extract the mains cable from the cable storage on the
rear of the device.
2. Make sure the control knob is at the "0" position.
3. Opening the swivel arm: Press the
swings upwards.
4. Place the mixing bowl in the holder and turn the bowl all
the way towards the marking.
5. Place all ingredients in the bowl.
6. Installing attachments: On the
upper end of the attachments,
there is a recess for the drive
shaft and the splint. Install the
desired attachment by inserting
the upper end into the drive
shaft. Push and turn the
attachment simultaneously anticlockwise in order for the
splint of the drive shaft to lock into the attachment.
7. Closing the swivel arm: Press and hold the
and at the same time lower the arm until it locks into place.
8. Then slide the splash guard onto the bowl. The filler
opening should be located on the left side (see the figure
on page 3).
9. Connect the mains plug to a certified wall socket.
10. Use the control knob to turn on the device and then select
a speed setting according to the table below.
Table Dough Types and Tools
Dough Type
Heavy dough
(e.g. bread or
shortcrust)
button. The arm
Tool Setting Amount
Kneading
1 - 2 max. 1.7 kg
hook
button
Max.
operating
time
5 min
31