Lindy 38130 Manuel Utilisateur page 4

User Manual
Overview & Operation
Front Panel
POWER MENU
1
1. IR Window
Receives IR commands from the supplied IR Remote
2. Power
Turn the Switch On/Off
3. Menu
 Press to launch the OSD menu
 Press to make a menu selection in the OSD
4. -/+ Buttons
Use these buttons to move up and down in the OSD
Channel Input (1 – 4) Selection
5.
 Use the Channel Input buttons to cycle through the available Inputs for each Channel; use Input
Channel button 1 to control Channel 1, Input Channel button 2 to control Channel 2 and so on.
For example if you have selected Channel 1, by default this will display Input 1, by pressing
Channel Input button 1 the Input will switch to Input 2, further presses will move the Input to 3 to 4
and then back to 1.
Window Mode (A – H)
6.
 Window A – Only the Input selected under Channel 1 will be displayed.
 Window B – Only the Input selected under Channel 2 will be displayed.
 Window C – Only the Input selected under Channel 3 will be displayed.
 Window D – Only the Input selected under Channel 4 will be displayed.
 Window E – The Inputs selected under Channels 1 – 4 will be displayed in a 2 x 2 grid.
 Window F – The Input selected under Channel 4 will be displayed on the right half of the screen,
the Inputs selected for Channels 1 – 3 will be displayed in on the left half of the screen.
 Window G – The Input selected under Channel 1 will be displayed full screen, with the Inputs
selected under Channels 2 – 4 will show (Picture in Picture) across the bottom of the screen.
 Window H – the Inputs selected under Channels 1 – 4 will be displayed in a 4 x 1 grid.
- +
4
2 3
A/1 B/2 C/3 D/4
WINDOW
CHANNEL
INPUT
1 2 3 4
5
6
E/ F/
G/ H/
English