Perel EDB7 Mode D'emploi page 6

8. Operation
8.1 Pairing the Transmitter to the Receiver
1. Make sure both the receiver and transmitter are powered.
2. Press the auto-learning code button on the receiver. Then, press the
push button on the transmitter.
The receiver will sound to indicate that the operation code has been
registered. One single receiver can memorize up to four different
transmitters. Note that you also can pair one transmitter to multiple
receivers.
If the receiver sounds for no reason during pairing, it could be due
to interference. In this case, please reset the code as per above.
8.2 Other Functions
Adjust the volume level, select the melody and activate the visual indication
by pressing the appropriate button.
9. Technical Specifications
operating distance
frequency
ringing volume
reception sensitivity
transmitting power
transmitting current
digital code
dimensions
chime (H x W x D)
transmitter (H x W x D)
power supply
receiver
transmitter
options
Use this device with original accessories only. Velleman nv cannot
be held responsible in the event of damage or injury resulting from
(incorrect) use of this device. For more info concerning this product
and the latest version of this manual, please visit our website
www.perel.eu. The information in this manual is subject to change
without prior notice.
V. 02 – 11/02/2016
EDB7
± 100 m (in open field)
433.92 MHz
> 80 dB (within 0.5 m)
≥ 80 dBm
≤ 10 mW
< 10 mA
auto-learning
110 x 70 x 45 mm (without socket)
85 x 32 x 20 mm
90-240 V~, 50/60 Hz, 2.2 W
1 x CR2032 3 V lithium battery (incl.)
lithium CR2032 3.0 V, 230 mAh battery
(CR2032C)
6 ©Velleman nv