Inserting / replacing the rechargea-
ble batteries (included and already
inserted)
Remove the battery compartment lid:
Push the front plastic cover upwards. A
certain resistance, caused by the lat-
ching, has to be overcome. (Figure 3)
Fig. 3
The plastic cover can now be taken
off, the battery compartment has
become accessible. Observe the cor-
rect polarity when inserting / replacing
the batteries (Figure 4).
Fig. 4
12 English
Attach the plastic cover: Lay the co-
ver onto the housing with approx 1 cm
distance to the lower edge (Figure 5).
Fig. 5
Push the cover downwards until it
clicks back into place. The front cover
is now attached again.
Indicators and controls
3 indicator LEDs are located under the
dark transparent front cover:
Microphone status indicator
This LED lights up whenever a ran-
dom sound triggers the activation of
the microphone.
Battery status indicator
A red battery status LED indicates that
the rechargeable batteries are almost
depleted and must be recharged. Du-
ring recharging, this LED will show an
orange light. A permanent green light
shows that the batteries are charged
and the »soundmonitor« is active.