Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2-Channel Wheel Radio W5 2.4 GHz
Instruction Manual
Content
4. Saftey Guides
11. Transmitter Function Notes
1. Introduction
Thank you for choosing 2.4 GHz radio remote control digital products,
if you are the first time to use this type of products, please read this
statement carefully and strictly in accordance with the requirements
of operation. You could refer to the manual if you meet any problems
during the operation. Please well keep the manual after use because
you might have to use it again next time. Once again, thanks for
buying our products.
2. Services
If you find any problems during the operation process, please refer to
the manual. If the problem still exists, you could contact our dealers
to find out the way to solve. You can also log on to our website
service center: www.ansmann-energy.com
3. The Special Symbols
Please pay attention to the following symbols if one of them are
appearing. Read carefully.
If the operator does not operate by following the
instructions the operator may lead to serious injuries
even mortal danger.
Danger
If the operator does not operate by following the
instructions the operator may lead to serious injuries
even mortal danger.
Warning
Instruction Manual
If the operator does not operate by following the
instructions the operator may lead to minor injuries,
but generally it will not cause serious injuries to the
operator.
Attention
Prohibition
4. Safety Guides
Don't drive at night, when it's bad weather such as
rainy or thundering. It will interfere the transmitter
signal. Thereby it will create out of control or
unexpected accidents.
Before you drive, please make sure the movement
of the server correspond with the direction of the
joystick. If inconcistent, please adjust before driving.
You need to turn the throttle channel (ch2) and
inching switch to the lowest before using. Then switch
on power, finally connect the receiver.
To shutdown the sequence turn off the receiver
power first and then the transmitter power. If those
operations are reverse, it might lead to uncontrolled
and cause accident.
5. Battery Charging
Notes
If your transmitter or receiver are using a nickel-
cadmium, nickel-metal hydride rechargeable battery, you
have to well-check before. If there is a lack of electricity,
it could happen those phenomenon like inadequate control or out of
control, is resulting an accident. So please charge immediately when
the battery shows a lack of electricity.
If you are using a nickel-cadmium or nickel-metal
hydride battery for recharging, please use our company
dedicated charger. If the electrical current is too large,
it may lead to temperature over-heated and cause fire
burning accident. Please cut off the power supply immediately after
recharging. Please take out the battery from the transmitter when
you are not using it within a period, because the battery may damage
the aircraft batteries.
Mandatory
Publicité
Chapitres
Table des Matières
