Publicité
Les langues disponibles
Les langues disponibles
EN
* In cases of IDE hard drives, the computer can only
recognize the storage enclosure when the hard drive is set
to master mode. To do this, put the jumper in the correct
position.
The IDE hard drive configuration image is indicative. The
way you set up may vary depending on different brands or
models. For more information, read the instruction manual
of your hard drive.
10
Master or single drive
Drive is slave
Master with non ATA
compatible slave
Cable select
4092 cylinder option may limit
drive
capacity
to
32
GB
depending on operating system.
master / slave
jumper settings
3. Secure the hard drive to the PCB board with the four
screws.
4. Insert the hard drive with the PCB plate into the hou-
sing and close it completely with the two screws.
Publicité
