Publicité
Les langues disponibles
Les langues disponibles
•
The temperature will automatically be selected.
•
The fan speed will automatically be selected.
Fan operation
•
Press the "Mode" button till the "Fan" icon appears.
•
Press the "Fan speed" button to adjust airflow speed.
Timer operation
Timer ON setting
•
When the air-conditioner is OFF, press the "Timer" button and
select a desired ON time and adjust by using the <Temperature
up> and <Temperature down> buttons.
•
The ON time can be adjusted to anytime in 0-24 hours.
Timer OFF setting
•
When the air-conditioner is ON, press the "Timer" button and
select a desired OFF time and adjust by using the <Temperature
up> and <Temperature down> buttons.
•
The OFF time can be adjusted to anytime in 0-24 hours.
Swing operation (oscillation mode)
•
Press this button to start the oscillation mode, the louver will
swing continuously up and down. Press button again to stop the
operation.
Sleep operation
•
In cooling mode, press the "Sleep" button to set the temperature.
The set temperature is increased by 1 degree within one hour to
a maximum of 2 degrees after 2 hours.
•
Press "Sleep" button to cancel the operation.
Drainage
•
After a lengthy operation and before storage, you will need to
drain the water that has been collected. Please prepare a
suitable location or tray to collect the water and remove the
rubber stop from the drainage hole at the bottom of the unit. The
water will then begin to drain. After this has stopped, you can
insert the drain stop.
Internal Tank Water Full Alarm Function
•
The inner water tank in the air-conditioner has one water level
safety switch that controls the water level. When the water level
reaches an anticipated height, the water full indicator lamp lights
up. Follow previous steps to drain the water.
INSTALLATION
•
The air-conditioner should be installed on a flat and stable
surface. Do not block the air outlet and allow at least 30cm
around the unit.
•
Socket wiring should be in accordance with the local electric
safety requirements.
Exhaust Hose Installation
•
Twist both ends of the hot-air exhaust hose(9) into the hose
connector window end(8) and the hose connector air conditioner
end(10).
•
Insert the hose connector air conditioned end(10) into the
openings at the back of the air conditioner.
•
Fix the hose connector window end(8) to the nearest windowsill.
Instruction manual
EN
9
Publicité
