Publicité
Les langues disponibles
Les langues disponibles
The spout can be swiveled to your desired
position. Make sure the spout is always
positioned within the area of the sink,
otherwise escape of water can lead to
serious flooding to your house or building.
CAUTION! DANGER OF SCALDING!
When making the hot water setting please
ensure that the temperature of the water is
not too high.
Before installation, make yourself familiar with
all the existing services, e.g. water connection
and stopcocks.
Please read carefully through these operating
instructions before installing and using
the product. Keep all the safety advice
and instructions in a safe place for future
reference!
˜ Installation
˜ Installing the tap
Turn off the main water supply to prevent
serious leakage of water. Allow any
remaining water in the pipework to drain.
Install the tap as shown in Figs. A to F.
m
CAUTION! Do not bend the hoses or place
them under tension. Otherwise material
damage could result.
˜ Flushing the tap
The tap must be flushed through before first
use to remove any dirt. To do this, follow
these steps (see Fig. H):
Screw the aerator
Open the main water supply and allow the
water to run for two minutes.
Then screw the aerator
˜ Setting the temperature limiter
The cartridge
in this product has a temperature
22
limiter. This function is not activated in the factory
(neutral setting).
m
CAUTION! Change the temperature limiter
setting only after the tap has been installed.
Follow Fig. G to set the temperature
limitation.
10 GB/IE
off.
2
on again.
2
Turn off the main water supply.
Remove the small plastic cover
by a small flat screwdriver.
Release the locking screw
anticlockwise using a hexagonal key.
m
CAUTION! Do not take the screw
completely out; just loosen it until the control
lever
can be easily taken off.
17
Take off the control lever
Loosen the cartridge covering ring
hand. Then, screw off the cartridge retaining
ring
by using a pipe wrench.
21
Now pull the cartridge
help of a screwdriver.
Note: Do not remove the cartridge
Place the setting ring
position (see Fig. I).
Tighten the cartridge retaining ring
the tap body
again by using a pipe
16
wrench. Then, tighten the cartridge covering
ring
by hand.
20
Place the control lever
body
. Tighten the locking screw
16
turning it clockwise using a hexagonal key.
Press the small plastic cover
opening.
Turn on the main water supply and check the
temperature limiter.
˜ Operation
˜ Bringing into use
Note: If the fitting has not been used for a long
period flush the pipes through thoroughly in order
to avoid stagnation and build-up of residues in
the drinking water supply.
Open the main water supply.
Lift the control lever
right or left in order to regulate the speed or
temperature of the water flow.
Check operation of the mixer. For this
purpose move the control lever
possible positions. Please regularly check all
connections to ensure that they are tight.
carefully
18
by turning it
19
.
17
by
20
upwards with the
22
.
22
in the desired
15
onto
21
back on to the tap
17
by
19
into the
18
and swing it to the
17
in all
17
Publicité
