Publicité
Les langues disponibles
Les langues disponibles
GENERAL INFORMATION
General
These are the mounting instructions for the Novy hood shown on the cover. The user manual is a separate booklet that
is also delivered with this hood. Carefully read these instructions before installing and commissioning the wall-mounted
chimney hood. It is recommended to have one or more qualified persons carry out the installation only.
Carefully take the hood from the packaging.
The hood should be installed above a cooker and/or domino, and is intended for domestic use.
Important before mounting
Page 2 of these mounting instructions show the mounting drawings. Observe the following mounting tips before starting
the mounting activities:
•
For easier mounting, it is recommended a minimum of 2 persons install the wall-mounted extractor hood.
•
Check the drawing on page 2 for any mounting materials that may be included.
•
Position the electrical socket so that it is behind the shafts of the extractor.
•
Ensure the wall has sufficient load-bearing capacity.
•
The protective foil on the stainless steel can be removed from the wall-mounted extractor hood or shafts before
mounting. Avoid damaging the stainless steel.
InTouch
InTouch provides the ability to operate the Novy hood from the Novy InTouch induction hob. A set can be ordered from
Novy which makes the cooker hood react directly to the operation of the cooking plate. This set by default includes a
remote control. Visit the website for the different models of induction cooking plates with InTouch.
The distance between the underside of the hood (1) and the working surface (2) must be at least 500 mm. This means
1
the distance between the flat side of the cut-out in the mounting bracket (3) and the underside of the hood (1) must
be 348 mm.
Mark the wall with the holes from the mounting bracket.
2
Drill appropriately-sized holes.
Attach the mounting bracket to the wall using the screws and plugs provided.
Hang the hood on the mounting bracket.
3
NOTE: both of the support profiles (4) must rest on the rims (5) of the mounting bracket in order to ensure secure and
stable attachment.
Secure the hood to prevent it from falling:
4
Slide the clamping plate along the wall against the hood, and screw to the wall using the supplied screw.
EN 6
Publicité
