Brandt Four Guide D'utilisation page 27

COOKING FUNCTION
TRADITIONAL
TRADITIONAL PULSE
CIRCULATING HEAT
PULSED BOTTOM
ECO
MEDIUM GRILL
FULL GRILL
GRILL PULSE
KEEPING WARM
PIZZA
BOOST
The cooking time is saved automatically after a
few seconds. The time starts to count down as
soon as the cooking temperature is reached.
4.4
DELAYED START
Proceed as for programmed cooking. After
setting the cooking time, press
end time flashes.
The display flashes. Set the cooking end time
with + and - .
The cooking end time is automatically saved after
a few seconds. The cooking end time display
stops flashing.
5
CLEANING THE OUTER SURFACES
Use a window washing product applied to a soft
cloth. Do not use abrasive creams or scouring
sponges.
PPYROLYSIS CLEANING
Before starting pyrolysis cleaning, remove any large
overspills, if any. Remove the excess grease on the
door using a damp sponge.
RECOMMENDATION
OF COOKING TIME
30 min
30 min
30 min
30 min
30 min
10 min
7 min
15 min
60 min
15 min
5 min
; the cooking
Cleaning
As a safety measure, cleaning only occurs after the
door locks automatically; it is impossible to unlock
the door.
Remove the accessories and supports
from the oven before beginning pyrolysis
cleaning.
5.1
REMOVING THE SHELF SUPPORTS
Lift the front part of the wire shelf support upwards.
Press the entire shelf support and release the front
hook from its housing. Then gently pull the whole
of the support towards you to release the rear
hooks from their housing. Pull out the two shelf
supports.
5.2
IMMEDIATE PYROLYSIS
The programmer must display the time of day and
must not be flashing. To activate the pyrolysis cycle,
turn the function switch to
safety measure, cleaning only occurs after the door
locks automatically. The symbol
is impossible to unlock the door. At the end of the
cleaning cycle, 0:00 will appear on the display and
the door will be unlocked.
Turn the function switch back to 0.
DELAYED PYROLYSIS
Follow the instructions described in the «immediate
pyrolysis» and refer to Chapter 4.4 to adjust the
pyrolysis end time.
After these steps have been completed, the start of
pyrolysis is delayed so that it finishes at the
programmed time. When the pyrolysis cycle has
finished, return the function selector to 0.
5.3
CLEANING THE INSIDE GLASS
To clean the inside glass, remove the door. Before
doing this, remove any excess grease with a soft
cloth and washing up liquid.
Warning
Do not use scouring cleaning products,
abrasive sponges or metal scrapers to clean
the oven's class door, which may scratch the
surface and lead to the glass breaking.
REMOVAL
Open the door fully and block it with the plastic
wedge provided in your appliance's plastic pouch.
Remove the first clipped glass panel:
ENGLISH
>Pyro: 2 hours. As a
appears and it