Mercola Standup SS10R Manuel De L'utilisateur page 26

Attaching the Standup to a Door
There are two casters included with this unit that need to be properly installed BEFORE hanging it on a door.
The casters need to be fully threaded into the inserts at the bottom of the unit as shown in figure 1B.
Step 1. Remove screws "C" from the back top side of the system, and screw them back in through the
slots in the Top Brackets "A" as shown in Figure 1a below, but do not tighten yet.
Step 2. Grasp the Standup firmly with the brackets upright and test fit it on the door.
Step 3. Determine the necessary bracket height to hold the system against the door while allowing the
casters to support the weight of the system.
Step 4. Carefully remove the system from the door and tighten screws "C" so the Top Brackets are at the
correct height determined in step 3.
Step 5. Slide Bottom Bracket "B" under the door towards the center with the slot on the side that the
Standup will hang.
Step 6. Hang the Standup back on the door and ensure a proper fit.
It is very important to ONLY SNUG the casters by hand!
DO NOT TIGHTEN WITH A WRENCH!
www.mercola.com 27