aldes C.Integra Notice D'installation Et De Maintenance page 18

Where the unit exhaust cannot be connected to ductwork discharging outside the dwelling, order exhaust unit 11071174 that can fi lter the air
discharged by the unit. Connect the exhaust unit to the fl exible hose on the vacuum unit's exhaust and install it in an accessible location so that the
fi lter can be changed regularly. If the fl exible hose is not long enough, add a length of duct to reach the desired area.
Installation of the exhaust unit based on the installation method for the vacuum unit.
- Vacuum unit installed under a kitchen unit:
Positioning the exhaust unit in an accessible location so that the fi lter can be changed regularly (ref. 11071175).
If necessary, add a ductwork section Ø 51 mm (length + 1 elbow max. + F-F sleeve) to place the unit in the chosen location.
Unit installed on a vertical wall:
If necessary, add a ductwork section Ø 51 mm (length + 1 elbow max. + F-F sleeve) to place the unit in the chosen location.
2.5. Customising the drawer front
The dustbag compartment drawer is supplied with two sets of two self-adhesive fi nishing plates so that you can tie it in with the colour of your
kitchen units - one set of white plates and one in brushed steel. Clean the drawer front before sticking on the plates.
Remove the protective fi lm from the plates once stuck.
The drawer is equipped with a white handle by default. It can be changed for the chrome-plated handled supplied as an accessory. Simply unscrew
the white handle and screw the chrome-plated handle in instead.
1 x adhesive white decorative
plate for drawer front
1 x adhesive brushed
stainless steel decorative
plate for drawer front
18
Ø 51mm
+
Ø 51mm
+
1 x white drawer handle 1 x chrome-plated drawer
handle