2. INSTALLATION
This unit can be installed in several ways: horizontally under a kitchen unit or vertically against a wall.
2.1. Horizontal position under a kitchen unit
1
Make sure that the height of your plinth is
compatible with this type of installation.
The plinth must be at least 145 mm high.
2
Min. height 145 mm
Make sure that locating the unit underneath the
kitchen unit does not prevent fi xing the skirting
board to the kitchen unit feet.
Cut out the plinth to the dimensions indicated.
Use the template on page 43 to help you.
3
Connect the fl exible hoses to the unit's suction inlet and outlet. Plug the 230 V and 24 V cables into the unit (see sections 2.3 and 2.4).
Position the unit underneath the kitchen unit making sure that the drawer front is in front of the plinth once this has been reinserted.
Connect the fl exible hoses to your suction and exhaust ductwork without sticking them (to allow subsequent maintenance). If the drawer
bottom touches the fl oor, the glides are not long enough or the fl oor is uneven. Use glides under the unit to raise it.
4
Insert the fi xing rod and loosen the fi xing feet to block the unit under the kitchen unit.
INSIDE SURFACE OF THE KITCHEN UNIT
SURFACE INFÉRIEURE DU MEUBLE DE CUISINE
5
IMPORTANT! BEFORE PUTTING THE PLINTH BACK:
- make sure that you have connected the 230 V and 24 V cables or that they can be accessed to connect the unit to the power
supply;
- move the unit switch to the ON position.
6
Put the plinth back and fi x it fi rmly. The plinth fi xing must be strong enough to withstand the mechanical constraints imposed by operating
the drawer. If this is not the case, reinforce the plinth fi xing.
PLINTH CUTOUT DIMENSION
DIMENSIONS DE LA DECOUPE
DE LA PLINTHE
FINISHED FLOOR
SOL FINI
200mm
4 ADJUSTABLE FEET
4 PIEDS RÉGLABLES
Max. height of long adjustable feet: 5.5 cm
Max. height of short adjustable feet
(fi tted to the unit by default): 2.8 cm
15
EN