SOLIS CITRUS PRESS PRO 845 Mode D'emploi page 25

Assembling your Solis Citrus Press Pro
Step 1. Step 2.
Pull the Juicer Press Arm up, away from the Motor Base, Place the Juice Collector onto the Drive Shaft on top of
until fully extended. the Motor Base. Ensure the Juice Spout fits into the
semi-circular groove at the front of the Motor Base.
48
Step 3.
Insert the selected Filter (fine or coarse) into the Juice
Collector, aligning the indent with arrow in the bottom of
the Filter over the corresponding tab with arrow in the
Juice Collector. Use the Coarse Filter for maximum pulp
content in the juice and the Fine Filter to decrease the
pulp content in the juice.
Step 4. Step 5.
Place the Juicing Cone onto the Drive Shaft Insert the Fruit Dome onto the underside of the Juicing
and press down lightly to lock the Cone Press Arm by aligning the tab on top of the Fruit Dome
into position. with the hole in the Juicing Press Arm. Hold onto the
Juicing Press Arm and press the Fruit Dome up and
backwards until the Dome locks into position.
NOTE: The Fruit Dome is keyed, and can only be inserted
in one way (this will ensure that it does not rotate
through operation).
Step 6.
Ensure the Anti-drip Juice Spout is pushed down into the
pouring position.
Step 7.
Place a suitable sized glass or jug underneath the Juice
Spout.
49