Atlantic RSS 2012 500 W Notice D'installation Et D'utilisation page 13

How to raise the room's temperature quickly every day : how to use the 24h
Auto function
To activate the 24h Auto function, set the mode selection wheel A to
You can switch off this function before two hours have expired by holding down wheel A for approx.
1 second.
Light B comes on. The heating light C is lit.
Your device operates at maximum power for 2 hours and then returns to normal operation (the same
as when set to ON).
When you activate the 24h Auto function, the 2h Boost function comes on.
The 2h Boost function comes on for a second time the following day 45 minutes before the program-
med time for the initial start and then at the same time every day of the week.
Example of use :
You wish to have your optimum comfort temperature at 7 AM.
On the first day, at 7AM, set the mode selection A to
power for 2 hours and then resumes normal operation after 2 hours.
On the following day and the days after, your device will heat at full power at 6:15 AM to provide your
comfortable temperature at 7 AM.
To activate the 2h Boost function outside the set hours for the 24h Auto function, press the mode
selection wheel A.
You can switch off this function before the two hours have expired by holding down wheel A for
approx. 1 second.
Light B comes on. The heating light C is lit.
Your device operates at maximum power for 2 hours and then returns to normal operation (the same
as when set to ON).
To switch off the 24h Auto function, change the position of the mode selection wheel A.
Your device resumes normal operation. The 24h Auto function is deactivated.
Locking the controls: how to use the Locking function
This function enables you to lock the heating mode you have selected (e.g.: mode ON, temperature set
with the wheel on
To activate the Locking function, hold down the mode selection wheel A for more than 3 seconds
(the wheel may be at any position except OFF).
Light B flashes 5 times: the settings are locked.
The selected temperature cannot be altered.
You can still use the 2h Boost function by pressing wheel A (if the wheel A were set to ON or
To switch off the Locking function, hold down the mode selection wheel A for more than 3 seconds.
Light B flashes 5 times: the settings are locked.
You can change the position of the mode selection wheel A but any changes will not be registered.
- If you change the position of the mode selection wheel A, light B flashes.
- If you change the position of the temperature setting wheel D, the temperature will not
change.
). It is used to prevent any untimely operation of the device (by children, etc.).
.Your device starts to heat at maximum
13
.
GB
).