Tokai TC-132 Manuel D'utilisation page 15

'SNOOZE/SLEEP' (1) button. When sleep timer is selected, the unit
will automatically turn off once time is up.
RADIO MODE
Note: Ensure that the FM antenna is completely unrolled and
extended to have the best FM reception.
Press the ON/OFF button (10) to turn the unit on.
Use the Tune + (8) or Tune – (4) button to select the desired FM
radio station. If you press and hold the Tune + or Tune – button for
3 seconds, then release, the unit will automatically scan to the next
broadcasting station.
Press the ON/OFF button (10) to turn the radio OFF.
To preset radio station
Press the 'ON/OFF' button (10) to turn the unit ON.
Use the 'Tune +' (8) or 'Tune –' (4) button to select the desired
radio station.
Press the 'SET MEM/M+' (9) button; "P02" will blink in the display.
Press the 'SET MEM/M+'' (9) button again to set the preset.
Repeat steps 2 through 4 to set more presets. The unit can preset 10
stations totally for FM.
When "P01-P10" blinks, press 'Tune+' (8) or 'Tune-' (4) button to
select the preset number.
To recall the radio preset
To recall a preset station, press 'SET MEM/M+' (9) button to select
the desired preset number.
RESET
If the system does not respond or exhibits erratic or intermittent
operation, you may have experienced an electrostatic discharge (ESD)
or a power surge that triggered the internal microcontroller to shut
down automatically. If this occurs, simply disconnect the ac power
cord and remove the system backup battery, wait at least 3 minutes
and then setup the unit again by following the manual.
15