Tokai TC-132 Manuel D'utilisation page 13

Description of the display & indicators
LED DISPLAY
TIME INDICATOR
PM Indicator
ALARM 1 Indicator ALARM 2 Indicator
BASIC OPERATIONS
TIME SETTING
In standby mode, press and hold the SET.MEM / M+ button (9):
"24 Hr" will blink. Press the Tune + (8) or Tune – (4) button to set
the hour format between 12 hour (12 Hr) format and 24 Hour (24 Hr)
format.
Press the SET.MEM / M + button (9) and the hours will blink.
Press the Tune+ (8) or Tune – (4) to set the current hour.
Press the SET.MEM / M + (9) button again then the minute digits
will blink. Press the Tune + (8) or Tune – (4) to set the current
minutes.
Once setting done, press SET.MEM / M + (9) button once again to
indicate the current time is set.
ALARM SETTING
Press the AL.1 / AL.2 button (2/3) once to preview the alarm time.
The alarm time is displayed and will blink, press & hold the AL.1 /
AL.2 button (2/3) for 3 seconds and the hours will blink. Press the
Tune + (8) or Tune - (4) to set the alarm hour.
Press the AL.1 / AL.2 button (2/3) again; the minute digits will blink.
Press the Tune + (8) or Tune – (4) to set the alarm minutes.
Press the AL.1 / AL.2 button (2/3) to set the alarm sound mode:
Buzzer or Radio. The alarm sound mode will blink. Press Tune + (8)
or Tune – (4) to set the alarm sound mode.
If you select alarm sound mode with Radio, the volume will blink on
the display.
13