Product Installation; Checklist Before Product Installation - Richway & Fuji Bio BIO-BELT 7000 Manuel De L'utilisateur

Product installation

Checklist before product installation

▪ Do not use the product in areas with high humidity or significant dust.
▪ Handle the BIO-BELT with care. Any physical impact such as dropping the BIO-BELT can damage inter-
nal components.
▪ Check the voltage before turning on the BIO-BELT.
- Voltage for the product: 120V
- Electric shock or damage to the BIO-BELT can result from improper voltage.
- The BIO-BELT and the controller must be the same voltage.
(i.e. 120V BIO-BELT + 120V Controller / 220V BIO-BELT + 220V Controller)
▪ Do not use the BIO-BELT if the plug, power cable, or power outlet has any damage. Always check for cuts
and scrapes to the power cable.
▪ Do not pull on the power cord or controller when unplugging the BIO-BELT.
▪ Use a dedicated outlet when operating the BIO-BELT. Problems may occur when sharing a power strip
with other devices.
Product installation
1. Connect the controller / power cable to the connection port of the BIO-BELT. To ensure a secure
connection, there should be no space between the connector and the outlet on the mat.
The connection may be tight at first.
Plug the controller / power cable into an outlet. Make sure the controller is rated for the same volt-
2.
age as the outlet.
NOTE: Use care when handling the controller / power cable to prevent accidental breakage. Do not
drop, stand on or place heavy objects on the controller / power cable. Never pull the power
cable to remove the plug from the receptacle, be sure to hold the plug.
<IMPROPER CONNECTION> <PROPER CONNECTION>
8