Publicité
Les langues disponibles
Les langues disponibles
Features
Transmitter
Front Panel
1
1. Power: Press this button to turn the transmitter on or off.
2. CH: Press this button to select the RF frequency and channel for each stereo channel.
• Match channels on the transmitter and receiver to get a signal.
• Watch the receiver's AF indicator and RF indicator to make sure a signal is being
received.
• If you receive interference, change to another channel until a clean signal comes through.
• To change the channel:
a.
Press the CH button to enter channel selection mode. Press once to adjust the Left
stereo channel and press a second time to adjust the Right stereo channel.
b.
Press the +/- buttons to cycle through the available channels. Set the transmitter
and receiver(s) to the same channel.
c.
When the desired channel number is shown, wait for ten seconds or press the CH
button again. When the channel number stops flashing, that channel is now
selected.
3. VOL: Press this button to adjust the incoming signal level using the +/- buttons. Press once to
adjust the volume of the Left stereo channel and press a second time to adjust the volume of the
Right stereo channel. When you are finished adjusting the voume, wait five seconds to exit
volume adjustment mode.
4. Display: This display shows the current channel, frequency, and AF volume level. See
more information.
5. Mono/Stereo: Press this button to change the wireless signal that is sent to the receiver to be
either mono or stereo. When mono is selected, both the left and right channels are sent to one or
more receivers. When stereo is selected, only one stereo channel is sent from each transmitter to
each receiver. Use the receiver's L/R button to select which stereo channel it receives.
6. +/–: Use these buttons to adjust the selected value on the Display.
2
3
4
5
6
Display
for
9
Publicité
