Publicité
Les langues disponibles
Les langues disponibles
Receiver
Top Panel
1. Antenna: The wireless receiver's antenna receives
the signal that is sent from the transmitter. Place the
antenna in a vertical position for best results in
transmitting the wireless signal. If the wireless signal
quality is poor, change the position of the antenna.
2. Mount: Use this M10 mounting point to attach the
receiver to a loudspeaker.
3. Display: This display shows the current channel,
frequency, and other settings. See
information.
4. +/–: Use these buttons adjust the selected value on
the Display.
5. Scan: Press this button to automatically scan for the
best available RF frequency and channel. See
Operation
for more information.
6. CH: Press this button to manually select the RF
frequency and channel. See
information.
7. L/R: Press this button to select which stereo channel
the receiver receives from the transmitter. This only
applies if both receivers are being used in a stereo
application. On both receivers, set the switch to the
appropriate positions that match the L/R speaker
configuration.
8. SQ (Squelch): Press this button to set an RF signal
level limit. Signals must come in above that noise limit
to pass through the squelch filter. Higher settings
allow for greater noise reduction and dynamic range,
but a setting that's too high can cause intentionally
quieter sounds to be silenced along with the noise.
Use the +/- buttons to select a Low, Medium, or
High level. Be sure to experiment with different
settings to find an optimal balance. Once you have
selected the desired level, wait three seconds to exit
the Squelch setup mode.
Display
for more
Operation
for more
1
2
3
4
5
6
11
Publicité
