Alto Professional Stealth Wireless Guide D'utilisation page 6

Example 2 – Stereo Operation
To send stereo signals through the Stealth Wireless transmitter to two receivers:
1. Connect your mixer's main outputs to the corresponding input channels on the Stealth Wireless
transmitter and connect the receivers' outputs to your loudspeakers' inputs. Keep all mixer
volume and transmitter volume controls at their minimum settings.
2. Power on the Stealth Wireless transmitter and receivers. Set their channels to matching numbers.
See the instructions for setting up the transmitter and receivers in
3. Adjust the transmitter and receiver antennas to a vertical position for best results in transmitting
the wireless signal. If the wireless signal quality is poor, change the position of the antennas.
4. Set the transmitter to Stereo and adjust the Volume control to get a strong signal without
clipping.
5. Turn on your loudspeakers, adjust the output level on your mixer, and adjust the Volume control
on the transmitter to hear the audio signal. If you hear noise in the signal, change to a different
channel until a clean signal comes through. See the instructions for changing the RF frequency in
Operation
for more information.
Receiver
Power
Powered Speaker
6
Power
Transmitter
Mixer
Operation for more information.
Receiver
Powered Speaker
Power