Publicité
Problem
Steam does not
stop automatically
after placing the
steamer head onto
the holder.
The board cover
becomes wet or
there are water
droplets on the
garment during
steaming.
Board is shaky
during use.
Board cannot
be tilted.
Possible cause
Steam lock function is
activated.
Steam has condensed
on the board cover
after a long steaming
session.
The poles are not
installed properly or the
board is not secured
onto the poles.
The board lock is not
fully inserted.
The board is not fully
secure in vertical
position.
Fail to press the board
tilting lever.
The board lock is out of
alignment.
Solution
Press once to deactivate
steam lock ( refer to
Leave it to dry before
storage. Replace the
board cover if it has
worn out. Purchase a
new board cover from
a Philips Authorized
Service Center.
Refer to
for correct
installation.
Insert the two board locks
fully until you hear a
"click" sound (refer to
Make sure that the
board tilting lever is in a
locked position before
attaching it to the poles
).
( refer to
Press the board tilting
lever to tilt the board
( refer to
).
Release the board lock
and ensure the board
tilting lever is in a locked
position. Adjustment of
the board lock along the
poles may need to be
done.
Secure the board lock
before trying to tilt the
board ( refer to
).
).
).
27
Publicité
