D-Link GO-RTW-N300 Guide D'installation page 5

Les langues disponibles

PRODUCT SET-UP

EASY SETUP WIZARD

Outlet

Internet

Router

Internet

Save

ADVANCED SET-UP (ACCESS VIA IP ADDRESS)

To configure GO-RTW-N300 manually connect your computer to the GO-RTW-N300 using the

ethernet cable. Then plug the GO-RTW-N300 into a wall. The power light will display as solid Blue.

Then simply open a browser window and enter the IP address in the browser address field:

GO-RTW-N300

Step 1

Find an outlet close to an Internet- enabled device.

Then, move the switch to "RT Mode" and plug

the GO-RTW-N300 into a wall outlet. Verify that the power

LED has turned Blue.

Step 2

Connect one end of the Ethernet cable into the Ethernet port of

the Internet-enabled device (e.g. modem, router) and then plug the

other end of this cable into the GO-RTW-N300 INTERNET port.

Step 3

Plug one end of the Ethernet cable into the GO-RTW-N300 LAN

port. Plug the other end of the cable into your PC 's Internet port.

You may also connect to the router wirelessly.

Step 4

From the computer you connected to the router, open a web browser

and go to http://192.168.0.1. Enter admin as the User Name, and

leave the Password field blank. You may use the Setup Wizard to

configure your GO-RTW-N300.

IP ADDRESS:

http://192.168.0.1

USERNAME:

admin

PASSWORD:

[blank]