Hama 00137429 Mode D'emploi page 4

3.1 Mounting the clamp
• Use the rubber pads and clamp parts that are appropriate for the diameter of your handlebar (A).
• For thinner handlebars, insert the reducing insert provided into the clamp and use the correspond-
ing part.
• Tighten the two fastening screws evenly using the 3-mm Allen key provided (B).
3.2 Mounting the smartphone holder on the clamp
• Press and hold the release buttons on the left and right of the clamp (C).
• Carefully insert the smartphone holder so that the snap-in hooks on the upper side of the clamp
are cleanly seated in the corresponding openings on the underside of the smartphone holder.
• Let go of the release buttons.
Note
Keep checking that the smartphone holder is securely seated.
• To remove the smartphone holder, press the release buttons and take it off.
3.3 Inserting and removing terminal devices
• Press the release button of the smartphone holder to open the holding jaws (D).
• Adjust the two support arms to the width of your terminal device.
• Insert your terminal device and fix in place by pressing the holding jaws together (E).
• Slip the elastic safety strap into the designated hooks on the clamp, to secure your terminal device
(F).
4. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from
improper installation/mounting, improper use of the product or from failure to observe the operating
instructions and/or safety notes.
5. Service and Support
Please contact Hama Product Consulting if you have any questions about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here:
www.hama.com
3