Panasonic CY-VHD9401U Instructions D'installation page 15

Installation
E
N (continued)
G
L
I
S
5
Connect the wires and attach the main unit.
H
15
1
See page 30`31.
1
Where the wires emerge
< Cord clamp
in the front seat side
a 2
(at 2 positions)
Where the wires emerge
in the rear seat side
< Cord clamp
(at 1 position)
a 1
28
CY-VHD9401U/L
1
Connect the wires (page 30 to 35) which
were pulled out in a previous step to the unit
(page 24).
Caution:
≥ When connecting stripped wires, be sure
to wrap them securely with electrical
tape to prevent shorts.
Note for connecting the dome lights
(page 30s31):
≥ There are two common types of dome
light circuits used, positive or negative
switched.
Positive systems supply voltage to the
interior lights to turn them on, negative
switched systems apply ground to
illuminate the bulbs.
≥ The dome light lead connection varies
depending on the type of vehicle. Consult
a service technician as needed.
≥ Both positive and negative switched
light circuits are supported by this
unit's door switch. If the door switch
is not wired correctly, the dome
light will not come on properly.
2 The polarity differs from one model to
another so be absolutely sure to ask a
dealer or service technician to wire and
install the unit.
2
Bind the wires using the cord clamps (<) after
connecting.
Bend the cord clamps about 5 mm {
their ends, pass the cord clamps through the
installation holes in the main unit's rear panel,
and then use them to secure the wires. Finally,
cut off the excess parts of the cord clamps.
Caution:
≥ Wires are never to be hit by the screws
or pinched between the plates.
Push in any extra wire.
q} from
1 /
4
3
Insert the bosses of the main unit underside in
the base plate guide holes.
Caution:
≥ If there is any extra wiring, push it
from the pull out opening to behind
the ceiling, taking care so that it is not
pinched between the main unit and base
plate. Failure to heed this caution may
result in an accident and/or injury.
4
Use a screwdriver to tighten the screws
(in 6 positions) that you previously tightened
loosely to secure fi rmly the main unit.
5
Insert the end of the panel, and push it
back into place as shown in the fi gure.
Secure the screws.
Note:
≥ Be careful not to scratch the surface of
the front cover when attaching it.
CY-VHD9401U/L
E
N
G
L
I
S
H
16
29