Publicité
Les langues disponibles
Les langues disponibles
Do not install this appliance in areas that are too humid or too colds, such as the
construction appendices, garages or wine cellars. Place the appliance away
from heat sources such as kitchen stove/oven, radiators, or direct sunlight. The
appliance must not touch any pipes for heating, gas or water supply, or any
other electrical devices.
Minimum distances from the heat sources:
- from the electric gas and other ovens - 30 mm,
- from oil or coal fired ovens - 300 mm,
- from built-in ovens - 50 mm
If there is no possibility of ensuring the above- mentioned distances, provide an
appropriate insulation board
Do not cover the ventilation holes at the top of the appliances – it must be a good air
•
circulation around the appliance. There should be a gap of at least 10 cm between the
top of the appliance body and any furniture that may be above it (see fig 2, page 1.). If
this requirement is not followed, the appliance consumes more electrical energy and its
compressor may overheat.
The appliance must stand on a level surface and must not touch the wall. If necessary,
•
regulate the height of the appliance by adjusting the levelling feet: by turning them
clockwise – the front of the appliance rises, by turning them counter clockwise – it comes
down. If the appliance is tilted slightly backward – the doors will close by themselves.
If the appliance is placed in a corner, a gap must be left between the appliance body and
•
the wall so that the freezer compartment door can be opened enough to pull out the
frozen product drawer (see fig. 3, page 1).
Preparing for operation:
It is recommended to prepare the appliance for operation with a helper.
•
Remove package. Lift the appliance away from foamed polystyrene base. Tear off
•
adhesive tapes. Remove all red-coloured parts from the shelves and coloured adhesive
tapes from the door trays. When placing, moving, lifting the appliance, do not
hold the door handles, do not pull the condenser at
the rear part of the refrigerator and do not touch the
compressor unit.
Take two supports 1 from the bag and insert them into the
•
guides 2 at the top back part of the appliance (see fig.).
The appliance should not be connected to the mains
until all packing and transport materials aren't removed.
First use:
Before using the appliance for the first time, the interior and all internal accessories
•
should be washed with lukewarm water and some neutral soap to remove the typical
smell of a brandnew product, then dried thoroughly.
Wait at least 4 hours before connecting the appliance to the
power supply. This is to allow the oil to flow back in the compressor. If
this is not done, the appliance compressor may fail.
When first starting-up or after a period out of use, before putting the products in the
•
compartment let the appliance run at least 2 hours.
5
Publicité
