Monster Power PowerCenter Haute Définition HDP IR 2550 Manuel De L'utilisateur page 23

IR "Learn Mode" (To Remotely Control the PowerCenter) IR "Learn Mode" (To Remotely Control the PowerCenter)
The PowerCenter's switched outlets can be switched On and Off with a Monster remote controller (sold separately),
or any universal remote controller with "learning" capability. To program a universal remote, you must "teach" it the
PowerCenter IR code:
A) Set your remote to "Learn" mode (refer to your remote's instruction manual).
B) Place your remote's learning sensor (see your remote's instructions) so that it is within five inches of and facing,
one of the PowerCenter IR Emitters.
C) To learn the ON code, press and hold the Dimmer button on the PowerCenter for 5 seconds. The green IR talk back
LED will flash 1 time.
D) Release the Dimmer button. The PowerCenter's IR code will now be sent through the IR Emitters. It should take a second
or two to be recognized by the universal remote.
E) To learn the OFF code, set your remote to "Learn" mode.
Press and hold the SWITCHED
•
Release the SWITCHED
•
a second or two to be recognized by your remote.
F) To learn the ON/OFF toggle code, set your remote to"Learn" mode.
Press and hold both the Dimmer and the SWITCHED
•
will flash 1 time.
Release both the Dimmer and the SWITCHED
•
the IR Emitters. It should take a second or two to be recognized by your remote.
HOOK-UP AND OPERATION INSTRUCTIONS
Power button on the PowerCenter for 5 seconds. The green IR LED will flash 1 time.
Power button. The PowerCenter IR code will now be sent through the IR Emitter. It should take
Power button. The PowerCenter's IR code will now be sent through
Power button at the same time for 5 seconds. The green IR LED
17