Monster Power PowerCenter Haute Définition HDP IR 2550 Manuel De L'utilisateur page 20

IR Setup Steps
The following steps for the Monster IR Control are relatively simple.
1. Make sure that you have already connected your AV components to the correct power outlets on the back of the
PowerCenter according to previous instructions.
2. Connect the external IR receiver to the "IR In" port on the back of the PowerCenter (see illustration).
3. Place the external IR receiver on top of your AV cabinet or in a location so that it
is visible from the couch or seating area of your home theater, or visible from where
you are going to use your remote. Make sure the front of the IR receiver is facing
towards your seating area.
4. Plug the IR emitter cables into any of the "IR Out" ports on the back of the
PowerCenter, and route the emitter cables to your AV components.
14
HOOK-UP AND OPERATION INSTRUCTIONS
��� ��� ����� ����� �����
��
�� ��
��� ��� ����� ����� �����