Loading The Trolleys - Jung JLB 3 K Mode D'emploi

WARNING
There is a risk of crushing when using transport vehicles
carrying loads. Always wear protective clothing and pay
attention to proper handling of the equipment.
NOTE
For safe lifting, the use of hydraulic JUNG jacks is
recommended.
NOTE
Observe the operating instructions of the JUNG jacks.
DANGER
Be sure to use the connecting rod for the individual
trolleys. As a result, the trolleys are guided parallel to
the load if the floor is even, clean and without steps.
Otherwise, tipping or slipping can lead to injuries or
even to fatal accidents. Secure the transport load.
CAUTION
Be sure to observe the order of the work steps.
- 46 -
Transport trolleys series K / S / G / H

4.4.1 Loading the trolleys

DANGER
Before the start of the lifting procedure, the centre of
gravity must first be determined. The trolley always
must be positioned closer to the centre of gravity than
the steering system, since a stable three-point bearing
can only be achieved in this way. Otherwise, tipping or
slipping can lead to injuries or even to fatal accidents.
> Using the jacks, lift the transport load step by step
in parallel and stabilize it with supports up to 5 mm
above the specified height.Due to the danger of
tipping, avoid large inclinations that can shift the
centre of gravity. This is particularly a danger for
unstable transport loads.
> Move the adjustable trolley (both cassettes)
underneath the transport load.
> Adjust and lock the connecting rod.
> Slowly and carefully lower the transport load onto
the trolleys.
> Use wedges to secure the trolley against rolling.
© JUNG Hebe- und Transporttechnik GmbH