Zibro R 263 T Manuel D'utilisation page 69

IRREGULAR FLAME AND/OR SOOT AND/OR SMELLS
THE HEATER SLOWLY EXTINGUISHES
THE HEATER REMAINS BURNING LOW
THE HEATER IS BURNING TOO HIGH
4
68
You have run out of fuel from the tank or the wick has been replaced.
After having refilled and replaced the removable tank, wait for 30 minutes
before igniting the heater.
You are pushing the ignition button » with too much force.
Push it in less forcefully (Section C).
The ignition coil ¸ is defective.
Contact your dealer.
The combustion chamber ¿ has not been positioned correctly.
Use the handle ´ to put it level, until you can easily slide it slightly to the left
and to the right and the chamber is level.
You are using fuel which is past its 'use by' date.
Start every heating season with fresh fuel.
You are using the incorrect type of fuel.
Refer to THE RIGHT FUEL (See Section 'What you need to know in advance').
Dust has gathered in the lower part of the heater.
Contact your dealer.
The wick height is not correct.
Contact your dealer.
The removable tank is empty.
See Section B.
The lower reservoir is contaminated by moist.
Contact your dealer.
The wick has hardened on the upper side.
Burn the heater until all fuel is used (Section G). Use the right fuel.
You are using fuel which is past its 'use by' date.
Start every heating season with fresh fuel.
Wick position too low.
Contact your dealer.
Before you refilled the tank, the heater had burnt up almost all the fuel.
After having refilled and replaced the removable tank, wait for 30 minutes
before igniting the heater.
You are using the incorrect type of fuel.
Refer to THE RIGHT FUEL (See Section 'What you need to know in advance').
The room is insufficiently ventilated.
Leave a window or a door wide open for a while.
You are using an incorrect, too volatile type of fuel.
Refer to THE RIGHT FUEL (See Section 'What you need to know in advance').
Wick position too high.
Contact your dealer.