Zibro R 263 T Manuel D'utilisation page 64

GENERAL DIRECTIONS FOR USE
Below you will find the main steps to be taken for
using your heater. For more details, please refer to
the MANUAL (pages 65 ff.).
1
Remove all packaging materials (refer to Section A, Fig. A).
2
Fill the removable tank ¾ and wait 30 minutes before you
ignite the heater (refer to Section B, Fig. G).
3
Insert the batteries into the battery holder ¹
(refer to Section A, Fig. F).
4
Check whether the combustion chamber ¿ is fully upright
(refer to Section A, Fig. E).
5
Ignite the heater by turning the knurled wick adjustment
knob · as far to the right as possible and then gently push
the ignition button » (refer to Section C, Fig. K and L).
6
After igniting the heater it will take 10 to 15 minutes before
you can check if the heater burns well (refer to Section D).
7
Switch off the heater (refer to Section E).
• As a fire precaution, the tank must be filled either
er has been switched off or in another room than the room where
the heater is installed.
• Always ensure that the tank is closed properly after filling it at a safe
distance from all sources of heat and open flames (see chapter B).
• Store all fuel containers
and dark place.
• Fuel ages. Use ne fuel at the start of every heating season.
• The use of Zibro Extra, Zibro Kristal or Zibro Bio as a heating fuel
assures you that you have a good quality fuel.
• Before changing brands and/or types of fuel make sure that the
mobile heater first completely empties all of the remaining fuel
inside the heater.
ith their original caps and seals in a cool
MAIN COMPONENTS
³
·
»
´
²
¶
º
hen the heat-
¾
µ
¸
¹
OFF - button
Knurled wick
adjustment knob
Ignition button
Combustion
chamber
Combustion
chamber handle
Fuel indicator
Grill
Lid for removable
tank
Removable tank
Fuel gauge
removable tank
Ignition coil
Battery holder
4
63