Delta 33-890 Manuel D'utilisation page 3

Read all instructions before operating the product. Failure to follow all instructions listed below may result
in electric shock, fire and/or serious injury.
FOLLOW ALL WIRING CODES and recommended electrical connections to prevent shock or
electrocution.
GROUNDING INSTRUCTIONS
If the saw is of grounded construction, read the following instructions.
SHOCK HAZARD. This machine must be grounded while in use. Serious injury could result.
ALL GROUNDED, CORD-CONNECTED MACHINES
In the event of a malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce
the risk of electric shock. This machine is equipped with an electric cord having an equipment-grounding conductor and
a grounding plug. The plug must be plugged into a matching outlet that is properly installed and grounded in accordance
with all local codes and ordinances. Do not modify the plug provided - if it will not fit the outlet, have the proper outlet
installed by a qualified electrician. Improper connection of the equipment-grounding conductor can result in risk of
electric shock. The conductor with insulation having an outer surface that is green with or without yellow stripes is the
equipment-grounding conductor. If repair or replacement of the electric cord or plug is necessary, do not connect the
equipment-grounding conductor to a live terminal. Check with a qualified electrician or service personnel if the grounding
instructions are not completely understood, or if in doubt as to whether the machine is properly grounded. Use only
three-wire extension cords that have three-prong grounding type plugs and matching three-conductor receptacles that
accept the machine's plug, as shown in Fig. A. Repair or replace damaged or worn cord immediately.
GROUNDED, CORD-CONNECTED MACHINES INTENDED FOR USE ON A SUPPLY CIRCUIT HAVING A NOMINAL
RATING LESS THAN 150 VOLTS
If the machine is intended for use on a circuit that has an outlet that looks like the one illustrated in Fig. A, the machine
will have a grounding plug that looks like the plug illustrated in Fig. A. A temporary adaptor, which looks like the adapter
illustrated in Fig. B may be used to connect this plug to a matching two-conductor receptacle as shown in Fig. B if a
properly grounded outlet is not available. The temporary adapter should be used only until a properly grounded outlet
can be installed by a qualified electrician. The green-colored rigid ear, lug, and the like, extending from the adapter must
be connected to a permanent ground such as a properly grounded outlet box. Whenever the adapter is used, it must
be held in place with a metal screw.
A
Grounding Pin
NOTE: In Canada, the use of a temporary adapter is not permitted by the Canadian Electric Code.
In all cases, make certain that the receptacle in question is properly grounded. If you are not sure, have a
qualified electrician check the receptacle.
GENERAL SAFETY RULES
SAVE THESE INSTRUCTIONS!
Grounded Outlet
B
Box
C
Grounding
Means
Adapter
3
D
Grounding Pin