Publicité
Les langues disponibles
Les langues disponibles
to the area where you place your feet
during the exercise).
It is advisable to lubricate the base of
the belt between the board and the
band every month, depending on how
often it is used.
If the belt starts to slip after lubrication,
then check the tension of the belt. To
tension the belt, take the 6mm Allen
key (142) and with the machine set to
4 km/h turn screws (R & L) one turn in
a clockwise direction.
Measurement
6KM/hr below 1 year
6~12KM/hr
Metric
12KM/hr
above
4mile/hr
below
English
4~8mile/hr
8mile/hr
above
Note: This preventive maintenance
schedule is only meant for home use.
It is suggested to maintain the unit
every month for commercial use.
ADJUSTING THE BELT.-
If your unit is not seated evenly on the
four contact points, this may cause the
belt (X) to shift sideways. Rigorous
quality control adjusts and checks the
running belt. However, due to weight
differences and individual styles of
running, the belt may be prone to shift
sideways. If the belt does shift to the
left or right, stop the machine.
BELT OFFSET TO THE RIGHT.-
This procedure is very important.
Follow these steps. In order to adjust
the belt, set the unit in motion at a
speed of 4km/h. If the belt has moved
to the right, turn screw (R) on the
Speed
Interval
6
months
3 moths
1 year
6
months
3 moths
right-hand side of the machine a 1⁄4
turn clockwise. Note the position of the
belt, if after one minute the belt is not
completely centred then repeat the
operation. If you see that the belt has
moved too far over to the left then turn
the right screw back slightly in an
anticlockwise direction Fig.13.
As soon as you have adjusted the belt
you can begin exercising again.
BELT OFFSET TO THE LEFT.-
In the event that the belt has moved to
the left, turn screw (L) on the left-hand
side of the machine a 1⁄4 turn
clockwise. Note the position of the
belt, if after one minute the belt is not
completely centred then repeat the
operation. If you see that the belt has
moved too far over to the right then
turn the left screw back slightly in an
anticlockwise direction Fig.13.
Important: Overtightening of the belt
can lead to a loss of speed on the
machine and even stretch the belt
itself. Bear In mind that one turn of the
right screw (R) in a clockwise direction
has the same effect on the position of
the belt as one turn of the left screw
(L) in an anticlockwise direction.
Consequently,
excessive belt movement you can use
either of the two screws in order to
avoid overtightening the belt.
OPERATING INSTRUCTIONS.-
FITNESS.
Being fit means living life to the full.
Modern society suffers greatly from
stress. City life is basically sedentary.
There are too many calories and too
much fat in our diet. All doctors agree
that regular exercise is a good way to
control our weight, make us fitter and
help us to relax.
20
in
the
event
of
Publicité
