Kärcher AFG 100 Mode D'emploi page 17

Colour level assignments (factory setting)
Colour level Colour
0 White
1 Red
2 Green
3 Blue
4 Red-yellow
5 Yellow
6 Yellow-green
7 Cyan
8 Cyan-blue
9 Magenta
10 Magenta-red
Note
The colours are adjustable when the brightness level is
set to "0".
Selecting the colour levels
You can configure up to ten colours and up to nine col-
our change intervals.
Selecting col- Press the "+" button to select the de-
our level 1...10 sired colour. Hold the "+" button
pressed to automatically change the
colour.
Press the "-" button to select the de-
sired colour. Hold the "-" button
pressed to automatically change the
colour.
Select colour Press the colour button twice in suc-
level 0. cession to select colour level "0".
Changing colour levels
You can manually assign any available colour to each of
the colour levels 1...10.
1 Press and hold the colour button until it flashes.
2 Press the "+" or "-" button to change the colour of the
selected colour level.
3 Press the Colour button again to save the colour un-
der the respective number.
Switching the lighting on/off
Switching the Press the Brightness button twice in
lighting on succession if the light ring lighting is
switched off.
 The lighting is set to the last level
selected.
Switching the Press the brightness button twice in
lighting off succession.
Setting the brightness of the light ring
1. Press the brightness button to set the brightness of
the light ring.
 The brightness button lights up.
Display
Display Meaning
0 The lighting is switched off.
1...10 Brightness level 1...10 is set.
Not adjustable
Adjustable
Adjustable
Adjustable
Adjustable
Adjustable
Adjustable
Adjustable
Adjustable
Adjustable
Adjustable
English
Setting the brightness levels
You can set up to ten brightness levels for the light ring.
Setting the Press the "+" button to increase the
brightness lev- brightness level. Hold the "+" button
els pressed to automatically change the
brightness level.
Press the "-" button to decrease the
brightness level. Hold the "-" button
pressed to automatically decrease the
brightness level.
Switching the timer on
1. Press the timer button to switch on the timer.
 The timer button lights up.
Setting the timer
You can set the timer within a range of 1 to 99 hours.
Setting the re- Press the "+" button to increase the re-
maining run maining run time. Hold the "+" button
time. pressed to automatically increase the
remaining run time.
Press the "-" button to decrease the
remaining run time. Hold the "-" button
pressed to automatically decrease the
remaining run time.
Display
The timer allows the device to be operated for a config-
urable period of time. The device switches off automat-
ically after the configured period of time.
The remaining time in hours is displayed when the timer
is selected. The displayed value changes when each
full hour expires, i.e. if "3" is displayed then the remain-
ing running time lies between 3.00 hours and 2.01
hours. The display does not change to "2" until the re-
maining time reaches 2.00 hours.
Display Meaning
0 The timer is reset.
1...99 A remaining run time of 1...99 is set.
Resetting the timer
Resetting the Press the timer button twice in succes-
timer sion to reset the timer to "0".
Measuring the air quality with the VOC
sensor
1. Press the Air quality button to measure the air qual-
ity with the VOC sensor.
 The air quality is indicated via the LED ring for ap-
prox. 10 seconds. The timer button lights up.
 The display shows "--".
 The LED ring lights up red during the air quality sen-
sor warm-up period.
Display
Display Meaning
Red Poor air quality
Yellow Medium air quality
Green Good air quality
17