Vacmaster VJC507P Manuel D'utilisation page 10

OPERATING INSTRUCTIONS: WET VACUUMING
3. Insert the locking end of the hose into the vacuum port on the collection tank and lock into
place.
4. Push the required attachment onto the free end of the hose or extension wand (Fig. 3).
5. Verify that the on/off switch is in the 'O' OFF position before plugging the power cord into the
power outlet. Plug the power cord into the outlet (Fig. 4 & 5).
6. Turn the motor on by flipping the switch to the 'I' ON position (Fig. 6).
7. Once you have completed vacuuming, flip the on/off switch to the 'O' OFF position and unplug
the power cord from the outlet.
8. After use, empty the collection tank, clean and dry the inside and outside of the collection tank
(Fig. 7).
IMPORTANT! When vacuuming large quantities of liquids, do not immerse the nozzle
completely in the liquid; leave a gap at the tip of the nozzle opening to allow air inflow. The
machine is fitted with a float valve that stops the suction action when the collection tank reaches
its maximum capacity. You will notice an increase in motor speed. When this happens, turn off the
machine, disconnect from power supply, and empty the liquid into a suitable receptacle or drain.
To continue vacuuming, refit the power head to the collection tank. After wet vacuuming, turn the
machine off and remove plug from power supply. Empty the collection tank, clean, and dry the
inside and outside before storage.
REMEMBER! The foam wet filter must be removed after wet vacuuming and the reusable cloth
filter must be installed before dry vacuuming again.
10