Silverline 621444 Traduction Des Instructions Originales page 7

621444
Fig. XI
50mm
50mm
50mm
50mm
50mm
50mm
1. Place the carrier against the vehicle approximately 50mm above the base of the tailgate
2. Adjust the Carrier (see 'Adjusting the carrier angle'), so it sits against the tailgate of the vehicle,
ensuring that the upper section rests in the upper or lower third of the panel on which it sits (not
the middle).
3. The Frame should be leaning towards the vehicle when in position whilst maintaining an
approximate clearance of 100mm from the vehicle. This gap will reduce as the straps are
tightened
Fig. XII
1. Once correctly positioned, attach the bottom straps to a secure place at the rear of the vehicle -
ideally the chassis or tailgate
WARNING: DO NOT attach the lower straps to the plastic bumper or other plastic parts as they
are likely to distort or break under load.
Fig. XIII
1. Attach the side hooks to the tailgate
2. Take up any slack from all straps
50mm
50mm
50mm
50mm
50mm
50mm
3. Progressively tighten each pair of straps in order: top/bottom/side
4. Repeat tightening process until the carrier is secure
Note: the clearance between the carrier and the bodywork and the carrier and the bumper will
decrease during tightening. Ensure that, once secure, there is a minimum of 5cm between the
carrier and the bodywork and that there is still clearance maintained above the bumper.
50mm
• Once the carrier is secured and checked, the bicycles can be mounted and secured to the carrier
using the straps provided or an alternative fixing method (not supplied)
• Ensure all moving parts of the bicycles are secured in a stationary position.
• The bicycles MUST be fixed to the carrier via the frame and mounted on the foam padded bars
ONLY, to prevent damage to the bicycles, carrier or vehicle.
• IMPORTANT: Ensure ALL bicycles are securely fitted to the carrier before travelling.
50mm
Maintenance
General inspection
Regularly check that all the fixing screws are tight.
Keep the carrier clean. Dirt and dust will cause parts to wear quickly and shorten the carriers
service life
Clean the carrier with a soft damp cloth using warm water. Do not use alcohol, petrol or strong
cleaning agents
Never use caustic agents to clean plastic parts
Lubrication
Slightly lubricate all moving parts at regular intervals with a suitable spray lubricant
Contact
For technical or repair service advice, please contact the helpline on (+44) 1935 382 222
Web: silverlinetools.com/en-GB/Support
Address:
Powerbox
Boundary Way
Lufton Trading Estate
Yeovil, Somerset
BA22 8HZ, United Kingdom
Storage
Store this tool carefully in a secure, dry place out of the reach of children
silverlinetools.com
Bike Rack
7