Silverline 621444 Traduction Des Instructions Originales page 5

621444
Assembly
Fitting the lower and side strap anchor buckles
Fig. I
1. Clip one of the Plastic Strap Buckles (5) on to one of the Angled Steel Anchor Loops (6)
Fig. II
2. Slide one of the M6 10 x 40mm Bolts (2) through the Angled Steel Anchor Loop (6)
Fig. III
3. Push the Bolt with the Loop through the Buckle Mounting Hole (11) on the Frame (1)
Fig. IV
4 Clip one of the Plastic Strap Buckles on to one of the Flat Steel Anchor Loops (7) (Fig. I)
5. Next place the Flat Steel Anchor Loop (7) on the protruding Bolt followed by a Washer (4) and an
M6 Nylon Locking Nut (3)
Fig. V
6. Using two 10mm spanners (not supplied), tighten the nut, but do not overtighten to allow for
adjustment
silverlinetools.com
Bike Rack
5